A firm Mold Release Paste Wax based on the highest quality refined Carnauba Wax blended with other synthetic high temperature ingredients and petroleum distillates.

PRODUCT FEATURES:

★ Ease of application and removal. May be allowed to stand at length and still polish wipe easily.

★ Provides hard film with superior heat and chemical properties.

★ Polishes to high gloss without streaking.

★ Reduced wax build up and styrene accumulation.

 

PHYSICAL PROPERTIES:

Dry Time: 5-10 minutes @ 720 F. Will vary depending on working temperature. Melt Points: 180-2100 F Penetration Hardness: 1 at 250 C (Carnauba Wax) Color: Light blue tint. Color-coded for identification.

 

USES:

As release agent for Polyester/Fiber Glass molding on all FRP tooling, Formica, metal and other hard surface molds.

★ Open mold hand or spray lay-up

★ Compression molding

★ Resin transfer molding (RTM)

★ Vacuum bag

NOTE: Check suitability when heat curing or higher temperature molding above 2000 F. (940 C).

PARTALL Paste #2 is a general purpose polishing compound made from a blend of hydrocarbon and microcrystalline waxes. It is particularly recommended for use on molds where standard silicone waxes hinder post-finishing operations or as a primer coat to create a smooth mold surface prior to application of PARTALL Film #10. PARTALL Paste #2 may also be employed as an inexpensive edge wax on larger molds.

Directions for Use:

New / Reconditioned Molds:

Using a clean dry cloth, apply a thin even coat of Partall Paste #2 to mold surface, covering 3-4 square foot sections at a time. Excess should be wiped away, also using a clean dry rag. Begin buffing immediately (approximately one minute after application) either by hand or with a power buffer equipped with a terry cloth or lamb’s wool pad. Keep power buffer moving constantly so as not to allow a build-up of friction that could burn through the wax coating. Surface should be buffed to a glossy finish. In order to insure complete coverage, repeat entire process 3-4 times for initial molding cycle. Alternate rubbing motions during application of each coat (i.e., up-down, left-right, circular). Apply one coat of PartallPaste #2 following each cycle thereafter until mold is broken in. Wait at least one hour after application of final coat before proceeding with molding.

Seasoned Molds

Using the same process described for new molds, apply one coat of Partall Paste #2 to mold surface and buff. Re-wax mold as necessary.